![]() ![]() The clarity is excellent and I can’t fault it. If you have no clue how to do it right, or have difficulty in getting rid of DSP-Quattro 4.4, the removal solutions provided in the post could be helpful. I use one speaker output channel to run 4 HF drivers, and with the volume level at -12db, so the amp is only outputting at about 60-70 watts and this is more than enough. Each HF driver is 16 ohms, and there are two in each cabinet. (EDIT: I bought two more of these amps to run the HF drivers in my 16 box line array, with 8 boxes per side. (EDIT: I have since worked out how to take the input from channel A and use it to drive all four speaker outputs)Ĭonsidering buying more to run my FOH high frequency drivers. But some XLR splitter leads can navigate that issue. That would be very handy for particular circumstances, especially since there aren't any XLR thru's to link channels. Sadly you can't currently send Input A to say Outputs ABC&D. For example, Input A will send the source to Output A and B. See the FAQ here below to know the differences. From within the menu you can pair up XLR inputs to XLR channels. The versions of the same applications available in DSP-Quattro Store are NOT SANDBOXED. The interface is great and very straight forward with lots of features I'll likely never need, but it's great to know it's there. The main attraction meant I could have a single rack that connected the two amps directly to my Midas D元2 stage box, with all the speaker DSP in there too, making for a very compact and quick gig set up. I was unsure about how well these amps would perform, but after getting them hooked up to my wedges (250w 8ohm speakers) there was little doubt that I'd retain all the power I had before and make a lighter rack case. I bought two Quadro 500 DSP power amps to ditch four very heavy amplifiers that were taking up 8U of rack space. I don't know if there are any amplifiers that can compare with this one for the price, and maybe even even more expensive amplifiers. Universal Binary support: DSP-Quattro runs natively on Macs based on Intel processors. I REALLY recommends this amplifier, especialy for home use (Example home teatre/home cinema, multi way setups and sub arrays) It's easy to use! Both the software and the on board controller works really great to set up, load, save and adjust presets and settings. There are two temperature controlled 80mm fans placed at an angle inside, pulling air from front and side and pushes it out on right side. I have measured it to deliver 4圆40w 4 ohms 1% THD so i am quite happy!Īlso, i was exited to find out about noise from the fans. c) In the new windows click on the tab 'Recording' and right click in the window and click on Show Disabled devices. b) Click in Sound, then a new window will open up. Follow these steps to do the same: a) Go to Start and click on Control Panel. What i was unsure about was the ratings, it dosesn't say much about load/ohm/watt at what THD. Try to set Headset as the default device. No coloring of the sound as far as i am concerned ![]() Sound quality is great! Nothing to say about it! It's class D. I was very unsure, but it turned out that the amplifier was very good. I ordered this amplifier because i have a 2 way system at home. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |